
CONCEPTRONIC C150APRA2 ENGLISH
65
The following table describes the parameters in this page.
Enter the name of the traffic class.
Select or deselect the check box to enable or disable QoS
classification.
SPECIFY TRAFFIC CLASSIFICATION RULES
Select L1&L2 or L3&L4 from the drop-down list.
L1&L2 maps to the features of layer 1 and layer 2, such as
the MAC address.
L3&L4 maps to the features of layer 3 and layer 4, such as
the IP address and the port.
Select the physical port of the packet from the drop-down list.
For example, ethernet1, ethernet2, ethernet3, and ethernet4.
Enter the source MAC address of the packet.
Use mask 000000ffffff to mask the MAC address. 00 indicates not
mapped and ff indicates mapped.
Enter the destination MAC address of the packet.
Use mask 000000ffffff to mask the MAC address. 00 indicates not
mapped and ff indicates mapped
Select the layer 2 protocol type from the drop-down list. For
example, IP protocol and IPX protocol.
Select the 802.1p priority of the packet from the drop-down list.
You can select no assign or a value in the range of 0—7. Note that
this function is not supported at the moment.
SPECIFIC TRAFFIC CLASSIFICATION RESULT
Assign Classification
Queue
Specify the queue to which the packet belongs. You can set the
queue in the classification configuration.
Attach the DSCP mark to the mapped packet.
Attach the 802.1p mark to the mapped packet.
Click Apply to save the settings.
Komentarze do niniejszej Instrukcji